Configurator

Calibration grade (calibrationGrade)

Higher grade means better accuracy estimate.

Communication protocol (communicationProtocol)

How the controller is connected.

Device online? (deviceOnline)

Computed: true only if power is OK (demo constraint).

Estimated accuracy (accuracy_percent_rd) [%RD]

Computed: rough accuracy (% of reading) influenced by calibration and operating point.

Estimated response time (responseTime_ms) [ms]

Computed: rough response time influenced by valve size and operating point.

Feasible flow (feasibleFlow_ln_min) [ln/min]

Computed: what you realistically get after constraints are applied.

Gas factor (gasFactor)

Computed scaling factor based on gas type.

Gas type (gasType)

Pick the gas being controlled (affects achievable flow).

Inlet pressure (inletPressure_bar) [bar]

Pressure available before the controller.

Max achievable flow (maxFlow_ln_min) [ln/min]

Computed: estimated maximum flow for your selected valve, gas, and pressure.

Max temperature allowed (maxProcessTemp_C) [°C]

Computed from seal material selection.

Minimum pressure drop needed (minPressureDrop_bar) [bar]

Computed: minimum drop needed for stable flow control at your request.

Notes (notes)

Computed: short explanation of what limited feasibility (demo).

Outlet pressure (outletPressure_bar) [bar]

Pressure after the controller (downstream).

Power OK? (powerOk)

Computed: true if supply voltage matches recommendation.

Power supply voltage (powerSupply_V) [V]

Supply voltage available (usually 24V for industrial setups).

Pressure drop (pressureDrop_bar) [bar]

Computed: inlet minus outlet pressure.

Pressure OK? (pressureOk)

Computed: true if pressure drop is sufficient.

Process temperature (processTemperature_C) [°C]

Gas temperature at the controller.

Recommended power (recommendedPower_V) [V]

Computed voltage recommendation for the chosen protocol.

Recommended valve size (recommendedValveSize_mm)

Computed suggestion based on requested flow and conditions.

Requested flow (requestedFlow_ln_min) [ln/min]

Flow you want (normal liters per minute).

Seal material (sealMaterial)

Choose seal material (affects max allowed temperature).

Selected valve size (valveSize_mm)

A simple valve/orifice size choice. Bigger typically allows more flow.

Temperature OK? (tempOk)

Computed: true if temperature is within seal capability.

Valve size OK? (valveOk)

Computed: true if selected valve size meets the recommended size.